First, stepper servo motor oil and water protection A: The stepping servo motor can be used in places where it will be affected by water or oil droplets, but it is not fully waterproof or oil proof. Therefore, the stepper servo motor should not be placed or used in a water or oil-infiltrating environment. B: If the stepping servo motor is connected to a reduction gear, the oil seal should be used when using the stepping servo motor to prevent the oil of the reduction gear from entering the stepping servo motor. C: Do not submerge the cable of stepper servo motor in oil or water. Second, stepping servo motor cable → relieve stress A: Ensure that the cable is not subjected to moments or vertical loads due to external bending forces or its own weight, especially at the cable exit or connection. B: In the case of stepper servomotor movement, the cable (that is, the one that is configured with the motor) should be firmly fixed to a stationary part (relative to the motor), and an additional cable installed in the cable holder should be used. To extend it so that bending stress can be minimized. C: The elbow radius of the cable is as large as possible. Http://xfoyo.taobao.com Third, the stepper servo motor allows the shaft end load A: Ensure that the radial and axial load control applied to the stepper servo motor shaft during installation and operation is within the specified value of each model. B: Be extremely careful when installing a rigid coupling. In particular, excessive bending load may cause damage or wear to the shaft end and bearing. C: It is better to use a flexible coupling so that the radial load is lower than the allowable value. This material is designed for high mechanical strength stepping servo motors. D: Regarding the permitted shaft load, refer to "Permissible Shaft Load Table" (Instruction Manual). Fourth, step servo motor installation attention A: When installing/removing the coupling part to the shaft end of the stepping servo motor, do not hit the shaft end directly with a hammer. (The hammer hits the shaft end directly, and the encoder on the other end of the stepping servo motor shaft is knocked out). B: Strive to align the shaft ends to the best condition (due to possible vibration or bearing damage).
Innosilicon Asic Miner:Innosilicon A9 ZMaster,Innosilicon A9++ ZMaster,Innosilicon A9+ ZMaster
Innosilicon is a worldwide one-stop provider of high-speed mixed signal IPs and ASIC customization with leading market shares in Asian-Pacific market for 10 consecutive years. Its IP has enabled billions of SoC's to enter mass production, covering nodes from 180nm to 5nm across the world`s foundries including: GlobalFoundries, TSMC, Samsung, SMIC, UMC and others. Backed by its 14 years of technical expertise in developing cutting-edge IPs and ASIC products, Innosilicon has assisted our valued partners including AMD, Microchip and Microsoft to name but a few, in realizing their product goals.
Innosilicon team is fully devoted to providing the world's most advanced IP and ASIC technologies, and has achieved stellar results. In 2018, Innosilicon was the first in the world to reach mass production of the performance-leading GDDR6 interface in our cryptographic GPU product. In 2019, Innosilicon announced the availability of the HDMI v2.1 IP supporting 4K/8K displays as well as our 32Gbps SerDes PHY. In 2020, we launched the INNOLINK Chiplet which allows massive amounts of low-latency data to pass seamlessly between smaller chips as if they were all on the same bus. With a wide range of performance leading IP in multiple FinFET processes and 22nm planar processes all entering mass production, Innosilicon's remarkable innovation capabilities have been proven in fields such as: high-performance computing, high-bandwidth memory, encrypted computing, AI cloud computing, and low-power IoT.
innosilicon zec miner,Innosilicon A9 ZMaster,innosilicon a9 50ksol miner,innosilicon a9 miner,a9 50ksol zmaster Shenzhen YLHM Technology Co., Ltd. , https://www.apgelectrical.com